It’s been a busy week and very exhausting. So much so that this post was supposed to be out on Monday but by the time I’d gotten done with training and recovery, I had very little energy left to write and edit pictures and videos. So, here’s a some of the weeks run down
Coaching
Last weekend I spend my one rest day not actually resting that much, rather I headed out to finish my British cycling Level 2 Coaching award. It’s been a rather long journey as a handcyclist working on getting this qualification sorted out and I’m not ashamed to say that it took me three attempts. On my first attempt I managed to flip my mountain bike and fractured my ribs putting me in A&E and off riding for quite a few weeks. On my second effort there arose some debate about how to coach handcyclist, and how translate and develop material that would work within the boundaries of the existing coaching structures. After many conversations, I managed to get back on the course for the final day. Then under a hot blaring sun I presented my final lesson and along with quite a sunburn I managed to get my Level 2 coaching qualification.
Equipment changes
Along with all the training, I’ve also been working on matching my training bike up to the specs of the ULVTeam bike in order to get adjusted to the configuration I’ll be riding with. Recently I got a matching cassette so that the gear steps will be the same between bikes. I also got my discs situated and ready for the road testing I’d completed this week as well. But the biggest change came in a slightly mysterious package…

OK, it wasn’t that mysterious to me. I’d been talking with Chris at Draft Wheelchairs for a few days about this particular package. We went back and forth on some measurements and finally came to the conclusion that I just needed to try it. Chris was fantastic, as usual, with his tech knowledge and not only found me the parts I needed, but overnighted them to me with a note to try them to see if they worked before anything else. This was brilliant as I was hoping to get them situated for the road test this week. Big thanks to Chris at Draft Wheelchairs for all the info and the quick turnaround on the cranks.

In chatting about the bike design with ULVTteam, I discovered that the cranks they were using were shorter and narrower than those on my bike; 160mm vs 170mm and 5cm narrower. Realising this could be a crucial factor as I would be losing leverage and the width different could change how my muscles engage I opted to swap my stock cranks for some new ones, ASAP, so that I’d have time to get used to them.
I’m glad I did as the first ride on the new cranks proved to be a disappointment, with noticeable changes in power when compared to the same ride completed just days earlier. Then when I took the bike out for some road testing the other day, the same situation existed. With the change in leverage, my power levels just weren’t the same, and not by a small margin. This was very worrying.
With a reduction in power this lead to the idea that we might have to investigate changing the strategy for how the power is applied in order to compensate for the loss of leverage; basically, getting power via cadence. But in training there are a lot of options to work with. And on my ride yesterday, I opted to utilize some psychology. In a nutshell, I told myself that a change in equipment wasn’t going to diminish my power output. And pleasantly, it didn’t. Yesterday, even with the short cranks, I managed to set two PB’s in power!
New bigger equipment
The engineers at the University of Liverpool supplied me with this brilliant picture the other day.

This is the first I’ve seen of the bikes shells as one unit. Currently they are working like mad to smooth and polish the shell in addition to getting the seam between the top and bottom as smooth and close fitting as possible. Then, they’ll be one to assembling the inner components.
It looks like they are making great progress and road testing before Battle Mountain should be happening in the near future. Big thanks to the team for all the work they are putting into the bike.
More thanks
Speaking of thanks, I’d like to give a big thanks to my fried Dave K for proofreading my blog posts. Well, actually he read them and asked if I wanted him to point out my typos. So, a few messages went back and forth and hopefully I should look a bit more intelligent!
A wee teaser
This week I also got in another road test which I’ll be posting about shortly but in the meantime a small teaser from the road test this week